Using The Auto Take-Up Reel Unit; Attaching The Roll Core - Epson SC-R5000 Series User Manual

SC-R5000 Series/SC-R5000L Series User's Guide
D
Follow the on-screen instructions. When using
the media in the Auto Take-up Reel Unit, press
Feed to Take-up Position.
See the following for information on loading
media in the Auto Take-up Reel Unit.
"Using the Auto Take-up Reel Unit" on
U
page 55
Press Complete if you are not using the Auto
Take-up Reel Unit.
After a while, the message Ready to print. is
displayed on the screen and you can start
printing. Transmit the data to be printed from
the computer.
Using the Auto Take-up
Reel Unit
The Auto Take-up Reel Unit automatically takes up
media as it is printed, improving the efficiency of
unmanned operation.
The Auto Take-up Reel Unit for this printer can take
up media in either of the following directions.
Printed side out
Taking-up with printed side out places the printed
surface on the outside of the roll.
Taking-up with printed side in places the printed
surface on the inside of the roll.
You can check the procedure in a video on YouTube.
Epson Video Manuals
Basic Operations
Printed side in
55
Caution:
❏ Follow the instructions in the manual when
loading media or roll cores or removing
media from the take-up roll.
Dropping media, roll cores, or take-up rolls
could result in injury.
❏ Be sure that your hands or hair do not get
caught in the Media Feeding Unit or Auto
Take-up Reel Unit while it is operating.
Failure to observe this precaution could result
in injury.

Attaching the Roll Core

Prepare a roll core that is longer than the width of
the media to be wound.
This allows the media to be taken up without
protruding from the core.
A
Feed the media to the sticking position.
When performing operations after loading
the media
Follow the on-screen instructions. Press Feed
to Take-up Position to feed the media to the
sticking position.
When performing something other than the
above
Press and hold the
panel to feed the media to the media holder
position.
c
Important:
Do not pull the media by hand. If the media
is pulled by hand, the media may twist
during take-up.
button on the control