Using The Auto Take-Up Reel Unit; Notes When Using The Auto Take-Up Reel Unit; Attaching The Roll Core - Epson SureColor SC-S70600 series Operator's Manual

EPSON SC-S70600 series/SC-S50600 series
Using the Auto Take-up
Reel Unit
The auto take-up reel unit automatically takes up media
as it is printed. This improves the efficiency of
unmanned operation.
The auto take-up reel unit for this printer can take up
media in either of the following directions.
Printed side out
Taking-up with printed side out places the printed
surface on the outside of the roll.
Taking-up with printed side in places the printed
surface on the inside of the roll.
This section explains how to install media on the
standard auto take-up reel unit.
You can check the procedure in a video on YouTube.
"Video Manuals" on page 2
U
Notes When Using the Auto
Take-up Reel Unit
!
Caution:
❏ Follow the instructions in the manual when
loading media or roll cores or removing the
take-up roll.
Dropping media, roll cores, or take-up rolls
could result in injury.
❏ Be sure that your hands or hair do not get
caught in the media feeding unit or auto
take-up reel unit while it is operating.
Failure to observe this precaution could result
in injury.
Operator's Guide
Basic Operations
Printed side in
15
Use a roll core that is longer than the width of the
media.
This allows the media to be taken up without protruding
from the core.
Attach media to the roll core using the paper tape
supplied.
Using the paper tape reduces a take-up roll
misalignment error. When the supplied parts have been
completely used, purchase commercially available
paper tape with a width of 20 to 25 mm (that is not easily
stretched or cut). If you do not have any paper tape, cut
media into pieces of 20 to 25 mm wide and 60 cm long.
For ink layering, the auto take-up reel unit is not
available.
Take-up may not be possible, or print quality may
decline.

Attaching the Roll Core

Before starting operations, be sure to read the following:

"Notes When Using the Auto Take-up Reel Unit"

U
on page 15
A
Keep the d button pressed until the leading edge
of the media reaches the roll core holder.
c
Important:
Always press the d button to feed the media as
far as the roll core holder. If the media is
pulled by hand, the media may twist during
take-up.