Using The Polling Function; Polling Memory - Sagem MF9300 Operation Manual

ADVANCED TRANSMISSION METHODS

Polling memory

This feature allows your machine to automatically send a document previously scanned into memory when another
machine calls and polls your machine.
2
3

USING THE POLLING FUNCTION

A document should not be loaded in the machine when the following operation is performed. When used in
conjunction with the timer transmission function, only one polling job can be stored.
• If the other machine has enabled a polling security function ("Restricting polling access (polling security)"
Note
(p.39)), make sure that your own fax number (sender's number) is programmed in the key operator programs
("OWN NUMBER AND NAME SET" (p.99)), and ask the operator of the other machine to program your fax
number (the programmed sender's number with the lowest control number) appropriately in that machine.
• If the other fax machine is a Sagem machine (excluding some models), you may also need to program a
system number in your machine ("SYSTEM NUMBER MODE" (p.105)) that matches a polling permission ID
number programmed in the other machine.
1
Touch the [SPECIAL MODES] key in
fax mode, and then touch the
[POLLING] key.
SUB ADDRESS
SPECIAL MODES ADDRESS REVIEW
DIRECT TX MEMORY TX
POLLING
DUAL PAGE
PROGRAM
SCAN
To cancel polling, touch the [POLLING] key once
again to cancel the selection.
2
Touch the [OK] key.
OK
1/2
SCAN MODE
34
Your machine
If the address book
screen appears, touch
the [CONDITION
SETTINGS] key to
display the condition
settings screen. (p.8)
The [POLLING] key is
highlighted and the
polling icon appears.
You will return to the
condition settings screen,
and the polling icon will
appear in the touch
panel.
The other machine
1
4
3
Enter the number of the other fax
machine or touch an auto-dial key
(rapid or group key) (p.17).
0123456789
CORPO.TPS
HARP CORPORATION SAGEM
ACC.#-C
serial polling, touch the [NEXT ADDRESS] key and
repeat this step. (p.28)
When performing serial polling, an auto-dial
Note
key that includes a sub-address or
passcode (p.53) cannot be selected.
If the Condition Setting
screen appears, touch the
SPE
[ADDRESS BOOK] key to
display the address book
screen. (p.9)
The selected auto-dial
key is highlighted.
If you are performing