Sagem MF9300 Operation Manual page 47

OWN NUMBER SENDING
This function prints the date, time, your programmed sender's name, your programmed sender's fax number, and
the page number at the top centre of each page that you fax.
You can program multiple senders to enable the use of different sender names (maximum of 20).
To program a sender, see "OWN NUMBER AND NAME SET" on page 99.
Example of fax page printed out by the receiving machine
11-MAY-200X-FRI 03:00
(1)
(1) Date and time: programmed in the custom settings (See "CUSTOM SETTINGS" in operation manual for copier).
The order of printing the date and time may vary in some regions.
(2) Sender's name: programmed in the key operator programs. ("OWN NUMBER AND NAME SET" (p.99))
(3) Sender's fax number: programmed in the key operator programs. ("OWN NUMBER AND NAME SET" (p.99))
(4) Page number: 3-digit number appearing in the format, "page number/total pages" (only the page number
appears if you use manual transmission or Quick On-Line transmission). If desired, you can use a
key operator program to have the page number omitted. ("PRINTING PAGE NUMBER AT
RECEIVER" (p.101))
Position of sender's information
You can select whether the sender's information is added outside the printed fax image or inside the image in the
key operator programs ("DATE/OWN NUMBER PRINT POSITION SETTING" (p.101)). The initial factory setting is
outside the image.
Outside scanned data
SAGEM PLANNING DIV.
(2)
None of the transmitted
image is cut off; however,
the transmitted image is
longer than the scanned
image, and thus when
both the sender and the
receiver use the same size
of paper, the printed fax
may either be reduced or
split up and printed on two
pages.
FAX No.0666211221
(3)
Inside scanned data
P.001/001
(4)
The top edge of the
scanned image will be cut
off by the sender's
information; however,
when both the sender and
the receiver use the same
size of paper, the printed
fax will neither be reduced
nor split up and printed on
two pages.
45
3