Transmission By Auto-Dialling; Dialling And Group Dialling) - Sagem MF9300 Operation Manual

TRANSMISSION BY AUTO-DIALLING (RAPID

DIALLING AND GROUP DIALLING)

To send a document by auto-dialling (rapid dialling or group dialling), follow the steps below. To use an auto-dial
destination, you must first program the full fax number and name of the destination. Refer to page 12 for information
on auto-dialling and pages 69 and 73 for information on programming auto-dial destinations.
1
Perform steps 1 through 6 of "BASIC
PROCEDURE FOR SENDING FAXES"
(p.13).
2
Touch the [ADDRESS BOOK] key.
AKER REDIAL
Y:100%
ADDRESS
EPTION
BOOK
SUB ADDRESS
3
Touch the rapid key for the desired
destination.
READY TO SEND.
SAGEM SA CORPO. TPS
SAGEM
FREQUENT USE ABCD EFGHI JKLMN OPQ
4
Continue from step 7 of "BASIC
PROCEDURE FOR SENDING FAXES"
(p.14).
The address directory
screen appears.
This step is not
necessary if the address
directory screen already
appears (go directly to
step 3).
See page 9 for
information on using the
address directory screen.
The key you touched is
highlighted. If you touch
the wrong key, touch the
key again to cancel the
selection.
BASIC OPERATIONS
2
17