Servo Installation - Phoenix Model Sonic High Wing Instruction Manual

Elevator servo
Rudder servo
Throttle servo
elevator - rudder linkage
Hole
Screw
Control horn

servo installation

•
•
•
•
Control horn
•
•
Screw
7
Install the rubber grommets and brass eyelets into
the elevator, rudder and throttle servos. Test fit
the servos into the servo tray.
Mount the servos to the tray using the mounting
screws provided with your radio system.
Remove the covering from the hole as shown.
The elevator control horn should be mounted on
the bottom of the elevator at the leading edge,
IN LINE WITH THE ELEVATOR PUSHROD.
Cut the covering from the exit slot for the rudder
pushrod on the top of the fuselage, on the left side
of the vertical fin.
The rudder control horn should be mounted on
the left of the rudder at the leading edge,
IN LINE WITH THE RUDDER PUSHROD.