Phoenix Model Sonic High Wing Instruction Manual page 4

Tape
Thread connector
Snap
keeper
With the aileron and aileron servo centered, carefully place a mark on the aileron pushrod wire where it crosses the
hole in the servo arm. Using pliers, carefully make a 90 degree bend down at the mark made. Cut off the excess wire,
leaving about 4mm beyond the bend. Insert the 90 degree bend down through the hole in the servo arm. Install one
nylon snap keeper over the wire to secure it to the arm. Install the servo arm retaining and remove the masking tape
from the aileron. Repeat for the second aileron linkage.
Servo tray
20mm
Clevis
Silicone tube
3
Locate aileron servo mouting tray. Trim covering
•
from bottom of wing for aileron servo and tray. 6
minute epoxy the tray in place centered over the
aileron servo opening using the supplied spacer
blocks (trim to fit as needed).
Install aileron servo using hardware supplied
•
with radio gear.
Install the threaded connectors onto the aileron
•
torque rods.
Snap keeper
Thread connector
Thread one nylon clevis at least 6mm onto one of
•
the 2mm x 180mm threaded wires. Install a
silicone tube on the clevis. Attach the clevis to the
hole in the threaded connector. Locate one nylon
servo arm and using a wire cutter remove all but
two of the arms. Using a 2mm drill bit, enlarge the
third hole out from the cnter to accommodate the
aileron pushrod wire. Plug the aileron servo into
receiver and ceter the servo. Install the servo arm
onto the servo. The servo arm should be
perpendicular to the servo. Center the aileron and
hold it place using a masking tape.
Clevis
Aileron pushrod