This is a very important stage in the completion of
the model. The throttle must open and close fully -
without the linkage binding at either end of its travel.
Work by setting the "mid throttle" position first,
followed by the low and high. Once the linkage
Low throttle
Low throttle stick position
Switch
setting up the throttle
Mid throttle
Mid throttle stick position
Receiver - battery
has been properly set-up it can be adjusted
mechanically or by using the Travel Adjust, or
ATV/EPA feature on most modern transmitters.
Note: The final adjustment of the low throttle point
can only be carried out with the engine running.
High throttle stick position
•
Wrap battery and receiver in protective
foam padding.
Install the switch.
•
9
High throttle
Antenna exit