Phoenix Model Sonic High Wing Instruction Manual page 5

horizontal - vertical installation
Dowel
A A
Remove the covering
• Cut the covering from the holes for the wing
dowels in the fuselage. Glue the dowels in place
with C.A
Rubber band wing onto fuselage with suppied
•
rubber bands. See photo.
Center the wing. Cut the covering from the slots
•
in the fuselage for the horizontal stab and vertical
fin. Put horizontal stab on fuselage and center like
the wing, also level the stab to match up with the
wing. Mark the horizontal stab where it will glue
to the fuselage.
B
Trim the covering from the stab where it will glue
•
onto the fuselage. Cut only through the covering,
do not cut into the balsa.
Glue stab on with 30 minute epoxy and recheck
•
alignment.
A A
4
B
B B