Engine Installation; Installing The Rudder; Installing The Engine - Phoenix Model PC21 PILATUS Instruction Manual

Gp/ep size .61-.91 or 15-20cc scale 1:6 ¼ arf
Table of Contents

Advertisement

Instruction Manual
6. After the epoxy has fully cured, remove the
masking tape or T-pins used to hold the
stabilizer in place and carefully inspect the glue
joints. Use more epoxy to fill in any gaps that
were not filled previously and clean up the
excess using a paper towel and rubbing
alcohol.
7.
Installing the elevator using C.A glue as
installing the aileron.

INSTALLING THE RUDDER

Repeat step 1 - step 2 from the installing aileron
for the installing rudder.
C.A glue
46
47
C.A glue
48
PC21 PILATUS

ENGINE INSTALLATION

INSTALLING THE THROTTLE PUSHROD HOUSING
1. Install the engine mount.
2. Place the engine into the engine mount and
align it properly with the front of the cowling.
The distance from the firewall to the front of the
engine thrust washer should 120mm.
!
If your engine is equipped with a remote needle
valve, we suggest installing it into the engine at
this time.
3. Slide the pushrod housing through the hole in
the firewall, through the hole in the forward
bulkhead, and into the servo compartment.
4. Apply a couple of drops of thin C/A to the
pushrod housing where it exits the firewall and
where it passes through the forward bulkhead.
This will secure the housing in place.
5. Using a modeling knife, cut off the nylon
pushrod housing in front of the servo tray.

INSTALLING THE ENGINE

Locate the long piece of wire used for the throttle
pushrod. One end of the wire has been
pre-bend in to a "Z" bend at the factory. This
"Z" bend should be inserted into the throttle
arm of the engine when the engine is fitted
onto the engine mount. Fit the engine to the
engine mount using the screws provided.
10
C.A glue
49
- OS .61-.91 two stroke
50

Advertisement

Table of Contents
loading

Table of Contents