Using Installer To Set Up Connection And Install Software - Fuji Xerox DocuPrint CP116 w User Manual

 Using Installer to Set Up Connection and Install Software
NOTE:
• The following procedure sets up printer connection, and then install the print driver and software. If you have already
established printer connection, go to "Using Installer to Install Software" on page 40 to install the print driver and software
immediately.
Launching the FX Printer Installation Screen
1
Insert the Software Pack CD-ROM into your computer to start the FX Printer Installation screen.
NOTE:
• For Windows 8, Windows 8.1, Windows Server
the upper right corner of the screen, and then select Run setup.exe.
• If the CD does not automatically launch, perform the following steps.
a For Windows Server 2003, Windows Server 2008, and Windows Server 2008 R2, click Start
For Windows Vista
For Windows 8 and Windows Server 2012, right-click on the Start screen and click All apps
For Windows 8.1 and Windows Server 2012 R2, click
b Enter "D:\setup.exe" (in case your optical disk drive is D), and then click OK.
2
Click Setup Printer and Install Software.
3
If you agree to the terms of the License Agreement, choose I accept the terms of the license agreement,
and then click Next.
38 Printer Connection and Software Installation
®
and Windows 7, click Start
®
2012, and Windows Server 2012 R2, click the message displayed on
 
All Programs Accessories
on the Start screen

Run.

Run.

Run.

Run.