Identifying Print Driver Pre-Install Status (For Network Connection Setup); This Section Includes; Disabling The Firewall Before Installing Your Printer - Fuji Xerox DocuPrint CM305 df User Manual

Identifying Print Driver Pre-install Status (For Network
Connection Setup)
Before installing the print driver on your computer, print the System Settings page to check the IP
address of your printer.

This section includes:

• "The Operator Panel" on page 88
• "Disabling the Firewall Before Installing Your Printer" on page 88
The Operator Panel
1
Press the System button.
2
Select Report/List, and then press the
3
Select System Settings, and then press the
The System Settings page is printed.
4
Find the IP address under Network (Wired) on the System Settings page.
If the IP address is 0.0.0.0, wait for a few minutes to resolve the IP address automatically, and
then print the System Settings page again.
If the IP address is not resolved automatically, see
page 83.

Disabling the Firewall Before Installing Your Printer

NOTE:
• For Windows XP, Service Pack 2 or 3 must be installed.
If you are running one of the following operating systems, you must disable the firewall before
installing the Fuji Xerox printer software:
• Windows 7
• Windows Vista
• Windows Server 2008 R2
• Windows Server 2008
• Windows XP
The following procedure uses Windows XP as an example.
1
Click start → Help and Support.
NOTE:
• For Windows Vista, Windows Server 2008, Windows Server 2008 R2 and Windows 7 operating systems,
if you use Online Help, switch to Offline Help on Windows Help and Support window.
2
In the Search box, enter firewall and then press the Enter key.
In the list, click Turn Windows Firewall on or off and then follow the instructions on the screen.
Enable the firewall after the installation of the Fuji Xerox printer software is complete.
button.
button.
"Assigning an IP Address (for IPv4 Mode)" on
Network Basics 88