Table 13: *Rst Default Parameter Values; Table 14: Status Register Power On Condition - Ametek 801RP Series User And Programming Manual

Hide thumbs Also See for 801RP Series:

User and programming manual (84 pages)

Table Of Contents

Table of Contents

14.4.6. *RST

This command resets the AC source to a setting defined by the values in the register defined

by PON if valid or by the following factory-defined states:

Item

VOLT

CURR

OUTP

Note: For 1251RP: 9.2A For 801RP: 6A

Command Syntax

Parameters

Related Commands

- ESE register

- ESR register

- STB register

- SRE register

Note: Sending the *RST command will cause the unit to recall the REMOTE or LOCAL state

based on the setting of the SYSTem:KLOCk command. This may put the unit in local if this

state is set to 0. To avoid this, either set the SYSTem:KLOCk state to 1 or follow the *RST

command with a SYST:REM command. See SYSTem:KLOCk for information on the power

up remote / local state.

14.4.7. *SAV

This command stores the present state of the AC source to a specified location in memory.

Up to 8 states can be stored in nonvolatile memory.

Command Syntax

Parameters

Related Commands

RP Series