Ametek 801RP Series User And Programming Manual page 70

14.2.4. Limit Subsystem
This subsystem controls the voltage frequency and current limit of the power source. These
limits are set at the factory and depend on the power source rating. It is not accessible by the
user. The query format is accessible however.
Subsystem Syntax
LIMit:
FREQuency:
LOW?
HIGH?
VOLTage?
CURRent?
LIMit:FREQuency:LOW?
This command queries the lower frequency limit of the power source.
Command Syntax
Parameters
Query Syntax
Returned Parameters
LIMit:FREQuency:HIGH?
This command queries the upper frequency limit of the power source.
Command Syntax
Parameters
Query Syntax
Returned Parameters
LIMit:CURRent?
This command queries the maximum current limit the power source will operate at in the low
voltage range.
Command Syntax
Parameters
Query Syntax
Returned Parameters
58
Queries the lower frequency limit
Queries the upper frequency limit
Queries the upper voltage limit
Queries the upper current limit
LIMit:FREQuency:LOW <NRf>
Low freq limit [command protected]
LIMit:FREQuency:LOW?
<NR2>
LIMit:FREQuency:HIGH <NRf>
High freq limit [command protected]
LIMit:FREQuency:HIGH?
<NR2>
[SOURce:]LIMit:CURRent <NRf>
maximum current limit at low voltage range
protected]
LIMit:CURRent?
<NR2>
March 2011
[command
RP Series