Safety Vision OBSERVER 4120 User Manual page 38

36
Alarm (cont.)
Linkage Setup
• Channel: select the channels that are recorded for the
duration of this alarm
• Post Recording: enter the amount of time (between 1 and
30 minutes) the alarm records video after it is triggered
• Lock: select this option to Lock the video recorded during
this alarm
• Linkage IO output: select IO outputs 1 or 2 to be activated
during this alarm
• Output delay time: enter the amount of time (between 0
and 255 seconds) between when the alarm is triggered
and when the IO signal is sent
• Alarm Upload: select this option to upload the alarm
• Linkage screen: select a screen to appear on the monitor
while the alarm is active, either a single screen, or a split
screen with multiple channels; tap the Setup button to
select the channels that appear in each screen section
and the Duration (between 1 and 300 seconds) that it
appears on the monitor
• PB alarm duration: enter the amount of time (between 0
and 255 seconds)
• Alarm snap: select this option to capture a snap shot
when this alarm is activated
OBSERVER 4120 USER GUIDE