Fresh Water System - Regal 2700 Owner's Manual

Fresh Water System

All water systems need to be initially filled to operate. The following
steps apply to pressure water systems only.
1. Unscrew the "water fill" deck fitting. Fill the fresh water tank with
approximately 10 gallons of fresh water. Make sure the water source
is safe, clean water.
2. Find the fresh water pump breaker switch. Turn the switch to the
"on" position. The pressurized water tank will fill the entire system
with fresh water.
3. Open the faucet to allow any air to escape. Close the faucet when
there is a steady stream of water without air. You will hear the
pressure switch shut off the pump indicating the system is full.
4. If your vessel is equipped with a cold water transom shower repeat
step #3. If installed, the transom shower is on the port aft deck.
5. After these initial procedures, "top" the systm off with fresh
water. Water recirculating at the vent indicates full capacity.
6. Check for system leaks as evidenced by the pressure water pump
recycling even though no water is being used from the faucet.
!
AVOID PRESSURE PUMP BURN OUT!
DO NOT ACTIVATE THE FRESH WATER
SYSTEM WITH THE WATER TANK EMPTY
Equipment Operation
CAUTION
6-7