Canvas - Regal 2700 Owner's Manual

Equipment Operation

CANVAS

Standard canvas includes a convertible or bimini top with boot, bows
and hardware. Some models feature side and aft curtains. On bow
rider models, a tonneau cover protects the bow seating area.
To install a typical bimini top, unzip the top boot and remove it from
the bimini top. Store it for future use. Unroll the canvas and install the
front canvas snaps in place. Pull one of the canvas straps aft until tight
and install the clip to the eyelet. Install the other canvas strap to the
other side.
Zip the windscreen to the bimini top. Then attach the windscreen to
the windshield snaps. It may be necessary to unzip a portion of it to
access the snaps. Install the port and starboard side curtains. They are
marked for easy identification. If not, a visual inspection will indicate
their side. Install the aft curtain to the bimini top rear section and zip it
in place. It is a good idea to work out of the boat by fastening one side
of the aft curtain and working your way out of the boat. Remember to
take down the canvas above idle speeds. Make sure each canvas piece
is dry especially the clear window glass material. Roll all canvas parts
before stowing them. Folding canvas parts could permanently damage
them.
Convertible tops follow the same basic installation process.
On bow rider models install tonneau cover to snaps and lower center
windshield. Install pole in canvas receiver and tighten pole thrum screw.
CAUTION
!
TO PREVENT BODILY INJURY AND PROPERTY
DAMAGE,DO NOT TOW BOAT
WITH CANVAS UP. TOW BOAT WITH
CANVAS DOWN AND STORED IN THE COCKPIT.
FOR WATER CRUISE USE,
PLACE THE BIMINI OR CONVERTIBLE TOP
IN THE CRUISE POSITION.
6-63