Fine Adjustment Of Seat/Footplate Angle - Otto Bock BRAVO Racer Instructions For Use Manual

Ensure that the vertical position of the adjustment tube on the axle retainer/base frame
INfORMATION
is always the same on both sides.
Ensure that all screw connections are properly re-tightened before using the wheelchair.
INfORMATION
6.5 Fine adjustment of seat/footplate angle (Fig. 47, 48)
A profile rail is located on the underside of the seat tube (Figure 48). It is attached on both sides
by four nut sliders.
On both sides, loosen the screws of the second nut slider from the front (Figure 47, Marking
A/Figure 48, marking B). These sliders connect the cross brace to the seat tubes.
Loosen the two central recessed screws on the back of the clamps that guide the footrest bar
and cross brace until the cross brace moves easily in the clamp (Figure 47, marking B).
Now you can make fine adjustments to the seat and footplate angle by moving the cross brace
on the seat tube. Once you have found the desired position, retighten all screws.
Ensure that all screw connections are properly re-tightened before using the wheelchair.
INfORMATION
The correct torque for the screw (Fig. 47, marking A/B) is 10 Nm.
A
62
46
B
47
B
A
48