Program Operation - SunStar SSP-WE/3.5 Instruction Manual

Program Operation

The following chart shows the most general program flow.
Creating New Data
Select a sewing
size by sewing
machine types
and models.
Save sewing data
Edit
Read sewing data to
edit.
Set up a machine
model to use.
Determine sewing size.
Set up various default
values for sewing and
set up them again
according to usage.
Input configuration data
to create sewing data.
Edit the created
configuration and
sewing data again.
Set up the length and
width of sewing data
Appropriately apply
sewing attribute codes
such as Back Tack and
Overlap Stitch.
Apply mechanical
control command codes
such as Thread
Trimmer or Stop.
Send design serial
Finish
The defined sewing machine
model defines the sewing range
of output data.
The length and width defined by
the sewing range determine the
edit range and are symmetrica-
lly displayed on the center of
the screen.
Set up the length and width of
stitches to be used.
Use the inputted configuration
data to create the sewing data
according to the sequence.
19