Editing Configuration Data; Editing With The Mouse Point - SunStar SSP-WE/3.5 Instruction Manual

Editing Configuration Data

■ ■ Editing with Mouse Point
66
Data Tool Bar is available.
· · Add Configuration Point
For configuration data without sewing data.
① It is assumed that data exist as described in the
figure. Current Normal Line displays in blue, and
the rest of data (Spline)display in gray.
② Click Configuration Point Addition
(Upon selection, it gets concaved.)
③ Use the mouse' s left button to click configuration
data joints to be added. In Figure, Normal Line
No. 4 joint is selected. The joint displays in red.
④ Move Mouse Point where to add, and continuous-
ly click the mouse' s left button.
Then the inputting data is added based on the
initially selected joint.
⑤ Click the mouse' s right button to finish working.
At this time, the last point inputted to add is autom-
atically connected with the next point of the
existing configuration data point.
(In order to cancel additional configuration data that are being input, press
"ESC"on the keyboard.)
For configuration data with sewing data
① Click configuration data with sewing data.
(Normal Spline Stitch).② , ③, and ④ are identical
as described above.Add Configuration point.
⑤ Click the mouse' s right button to finish working.
At this time, the last point inputted to add is auto-
matically connected with the next point of the
existing configuration data point, and then sewing
data is again created.
If configuration data includes sewing data upon inputting configuration
data, and if you add, delete, move the selected configuration data, the
coexisting sewing data is also changed automatically.
in Tool Bar.