Selection Of Elements With The Mouse - SunStar SSP-WE/3.5 Instruction Manual

36

Selection of Elements with the Mouse

You can select data with the mouse. Configuration data and sewing data are
independently respectively. Therefore, upon clicking each data, the data is
displayed on the screen. As shown in the left figure, configuration data is
displayed in blue and sewing data is displayed in red, and the
mouse Icon is in cross-shape. If it moves into the tool bar, it
changes into an arrow. Place the mouse button on the sub-tool
bar and click the button, an item in the sub-tool bar is concave
like
data. In case of sewing data, each stitch data is selected. The selected joint of
configuration data is in circle-shape and in blue like configuration data. While
sewing data is displayed in red and in black to display stitch data. And
configuration data and sewing data are selected within the joint point range of -3
pixel~+3 pixel long and wide each. However, if two data exist in an
interval of 1mm upon selection, any point beside them may be selected.
Please, refer to it without fail.
. Select the data joint to configuration data and sewing