Start And Finish Of Program - SunStar SSP-WE/3.5 Instruction Manual

Start and Finish of Program

After installing the program on your computer, connect the Key-Lock
with the printer port. (Execution of the program without connection
occurs an Error message.) The program is installed on your selection
directory. You can find that the program is registered in a Start Menu-
Program directory on the left bottom of the monitor screen as follows:
(Refer to Installing the Program.)
[Ex:Start Menu Program-SunStar SSP3.5-SSP3.5]
① Click SSP-WE/3.0 registered as shown in the Figure or click the execution file in the
folder, which is actually installed, then you can execute the program.
② START Dialog opens as shown in
the left picture upon execution of
the SSDP program. Click "New
Data" to start the program.
③ To terminate the program, save
the file, select "Finish"in the file
menu, or click " Close" on the right
topupper of the program screen.
④ To plug out the Key-Lock during execution of the program occurs an Erro message in a few
seconds and the program is not executed. Therefore do not plug out the Key-Lock during
execution of the program. Please without fail to save sewing data prior to terminating the
program.
⑤ If you click and execute Start Menu-Program SunStar-SSP WE1.0, then click "ROM" in the
SSP Program menu, SSPWriter is not executed. In this case, execute SSPWriter directly,
or click "ROM" after execution of SSP in the folder which its program is installed.
15