Table of Contents
Advertisement
5) Installation of program unit
(for automatic trimming type)
A. Fix the bracket② onto the program unit①, using 4
fixing nuts③.
B. Then, use 2 fixing bolts④ to tightly fix the bracket②,
where the program unit ① has been adjusted, along with
the back cover.
6) Installation of belt cover
A. Fix the belt cover "A" ① to the machine' s body using 3 fixing screws②.
You can assemble it more easily if you slightly incline the machine.
When the assembly of the belt cover "A" is finished, insert the front side of the belt cover "C" ③ into the groove of belt
cover "A" ① and fix the back side with the fixing screw④.
B. Attach the belt cover "B" ④ to the table.
Please make sure that the belt do not intervene with the inside of the belt cover "B" ④.
7) Installation of synchronizer
(for automatic trimming type)
A. Installing on the servo motor
In case of installing the servo motor (in-built synchronizer), a
synchronizer sensor is attached to the backside of the arm.
The appropriate clearance between the synchronizer and the
pulley is 1.2mm.
12
[Figure 7]
[Figure 6]
[Figure 8]
[Figure 9]
Advertisement
Table of Contents
