Rom Data Serial Transmission - SunStar SSP-WE/3.5 Instruction Manual

ROM data serial transmission

■ ■ R R O O M M d d a a t t a a s s e e r r i i a a l l t t r r a a n n s s m m i i s s s s i i o o n n
① Connect the serial transmission cable to the computer and the 2070P dial
operation box. (Refer to the main composition items to connect). Before
transmission, set 2070P ready to receive transmission as explained in "zigzag
direct transmission" .
② Select "serial communication set button"
under menu.
③ "Serial communication dialogue"box will
appear after selection.
Port Setting: To start serial data
transmission to your computer,
you have to set communication
port for the serial cable
connected. The number of serial
ports can vary depending on
specifications of the computer.
Normally, desk top computers
have two and lap tops have one
serial port. As the current "serial
transmission"tool is connected
to 2070P, you can use COM-1
only.
As shown in the serial port setting
dialogue, you don' t need to
change values of each item. Use
the default values as they are, for
they have already been set to
comply with 2070P.
Port Checking: A function designed to check the serial transmission program
connections of 2070P and SSPz before starting serial data transmission.
Sending data window: It shows extended design data code transmitted to 2070P.
After data code transmission, your window will display "1: Download...Zigzag
Design" .
Receiving data window: It shows the code value after successful transmission to
2070P as below.
Zigzag file loading: A function designed to read ROM.zig extended design data for
2070P for transmission.
Data transmission button: It sends extended design data for 2070P it had read to
2070P.
Exit: Exits from the "Serial transmission dialog"box.
1. ZigCode: 55 (Command reception complete)
2. ZigCode: 66 (Normal data reception complete)
3. ZigCode: 77 (Command execution complete)
127