Creating Mechanical Control Commands - SunStar SSP-WE/3.5 Instruction Manual

■ ■ Creating Mechanical Control Commands
All mechanical buttons are summarized at the above Tool Bar. Please refer to
Tool Bar about each button' ' s function.
Mechanical control commands influence the machine directly and indirectly.
They are simply created as follows:
· · Sencond Origin Control Command
Second Origin Control Command is not to select sewing data, but to apply to any of
sewing range. The usage is similar to how to input Point Stitching Data. There are two
input ways: one is to input without sewing data, and another is to input with created
sewing data. In case of the former, upon inputting sewing data like Point Stitching, the
second origin is creat-ed, and the Jump is automatically created based on the actual
origin. In case of the latter, upon inputting the second origin at a certain place, the second
origin is created at the first sewing data and Jump created based on the actual origin. And
a new Jump to connect both sides is automatically created. The following shows how to
create the second origin for the latter.
① Sewing data should be created before creating
mechanical control commands. (Please refer to
"Creating Sewing Data" .)
② Click Second Origin
then the selected button gets concaved.
③ Place Mouse Point where to input Second Origin
at the edit range, and click the mouse' s left
button. Then a red circle dot is crated as shown
in the figure.
④ Click the mouse'right button when a red dot is
created, and Second Origin Dialog is displayed.
⑤ Click "OK"to create Second Origin, otherwise
click "Cancel" .
at Machine Tool Bar,
47