Zigzag Design Direct Transmission - SunStar SSP-WE/3.5 Instruction Manual

Zigzag design direct transmission

■ ■ Z Z i i g g z z a a g g d d e e s s i i g g n n d d i i r r e e c c t t t t r r a a n n s s m m i i s s s s i i o o n n
You can immediately transmit data as is
displayed on your edit screen. For example, if
you have inputted your own zigzag design on the
edit screen as follows, you can send the current
design to 2070P immediately.
Be sure to connect the serial transmission cable
to the computer and 2070P dial operation box.
(Refer to the main composition items to connect)
① Before sending the design on the edit screen to 2070P, you have to set 2070P
to receive transmission from SSP. Refer to the following.
1. Press both N1 and + key at the same time with the
power on.
Prog (or programming) will be displayed in the box
after trimming.
2. Press N2
The ROM pattern number and pattern shape number
will pop up (Ex.: 9-01. Different numbers can
appear)
3. Use + and - key to select the pattern shape number
you want to receive
Ex: 9-09).
Pattern shape number for input: Any number from 1
to 99 can be inputted. Here, the figure shows the
pattern shape number 9-09.
4. Press N1.
"down" will start to flash with beeping sounds from
the speaker.
125