Creating Configuration And Sewing Data; Creating Configuration Data - SunStar SSP-WE/3.5 Instruction Manual

Creating Configuration and Sewing Data

You can input each type using functional buttons in the sub-tool bar.
The phasic creation process of configuration and sewing data is shown
in the followings:
■ ■ Creating Configuration Data
1. To input with the mouse
· · Input Spline
① Use the mouse' s left button to input any functional button you
want. The selected button becomes concaved
② Put the mouse button on any sewing range. Mouse cursor
displays in cross-shape
③ Upon clicking the mouse' s left button at any input place, data
is inputted.
· ·
④ The configuration data of Spline is currently selected.
Therefore, upon inputting continuously, the input point
displays on the screen.
⑤ Click the mouse' s right button to finish inputting.
At that time, Spline displays on the screen, and the
button concaved by selection in the tool bar beco-
mes reduced at original state.
⑥ Click "Esc"in the keyboard to cancel data under inputting. This is not applied to
any data created by clicking the mouse' s right button (Applicable to all input
functions.)
· · Input Line
The order of ①, ②, and ③ are same. But, upon continuo-
us inputting, ④ of Spline displays just point. For point to
point input, lines are automatically connected. ⑤ and ⑥
are same to those of Spline.
.
+ +
39