Suggested Minimum Chassis Height - VIA Technologies EPIA-M920 User Manual

Each side of the mainboard should have a buffer zone from the internal wall
of the chassis. The side of the mainboard that accommodates the I/O coastline
should have a buffer of 1.00 mm. The side on the opposite end of the I/O
coastline should have a buffer of at least 5.00 mm. The two sides adjacent to
the I/O coastline should have at least a 10.00 mm buffer.
For the side that is close to the PCI slot, the buffer should be at least 100.00
mm if a riser card module will be used.

5.1.2. Suggested minimum chassis height

The figure below shows the suggested minimum height requirements for the
internal space of the chassis. It is not necessary for the internal ceiling to be
evenly flat. What is required is that the internal ceiling height must be strictly
observed for each section that is highlighted. The highest part of the ceiling
will be above the PCI slot.
F F F F igure igure 48 48: Suggested minimum internal chassis ceiling height (for fanless model) : Suggested minimum internal chassis ceiling height (for fanless model)
igure igure 48 48 : Suggested minimum internal chassis ceiling height (for fanless model) : Suggested minimum internal chassis ceiling height (for fanless model)
EPIA- - - - M920 EPIA M920 User Manual User Manual
EPIA EPIA M920 M920 User Manual User Manual
58