3.1. Clear CMOS Jumper
The onboard CMOS RAM stores system configuration data and has an onboard
battery power supply. To reset the CMOS settings, set the jumper on pins 2
and 3 while the system is off. Return the jumper to pins 1 and 2 afterwards.
Setting the jumper while the system is on will damage the mainboard. The
default setting is on pins 1 and 2.
Figure 35
Figure
Figure
Figure
35 35
35: CLEAR CMOS jumper diagram
: CLEAR CMOS jumper diagram
: CLEAR CMOS jumper diagram
: CLEAR CMOS jumper diagram
Table
Table 30
30: CLEAR CMOS jumper settings
: CLEAR CMOS jumper settings
Table
Table
30 30
: CLEAR CMOS jumper settings
: CLEAR CMOS jumper settings
Note:
Note:
Note:
Note:
Except when clearing the RTC RAM, never remove the cap from the CLEAR_CMOS jumper default
position. Removing the cap will cause system boot failure. Avoid clearing the CMOS while the system
is on; it will damage the mainboard.
Setting
Setting
Setting
Setting
Pin 1
Pin 1
Pin 1
Pin 1
Regular (default)
Short
Clear CMOS
Open
EPIA- - - - M920
EPIA
M920 User Manual
EPIA
EPIA
M920
M920
P P P P in 2
in 2
in 2
in 2
Pin 3
Pin 3
Pin 3
Pin 3
Short
Open
Short
Short
User Manual
User Manual
User Manual
47