Meaning Of The Symbols On The Display - REMEHA HMI Gas 610 ECO PRO Installation, User And Service Manual

HMI Gas 310/610 ECO PRO
Information menu:
Q
Reading the various current values.
Chimney-sweeping position:
B
Forced full or part load for CO
User menu:
W
Parameters at user level can be changed.
Heating programme deactivated:
C
The heating function is deactivated.
Manual mode:
E
Boiler is set to manual operation.
Service menu:
? Parameters at installer level can be changed.
Defect:
c Boiler indicates a fault. This can be seen from the e
code and red display.
Burner level:
I
Output level .
Outside sensor:
Z (Only if an outside temperature sensor is connected
= Accessory).
g Battery symbol:
Status of battery of wireless controller (if connected).
051112 - 125482-03
3.1.2.
measurement.
2
K

Meaning of the symbols on the display

On/Off switch (0/1):
/
After 5 lock-outs, the boiler must be switched off/on again.
Shunt pump:
b
The pump operates.
Central heating function:
D
Access to central heating temperature parameter.
Locking the keys:
d
Key lock-out is activated.
Yellow display with the symbols:
$ + K + Z (Maintenance message).
Water pressure:
e The water pressure is too low.
(Only with the hydraulic pressure sensor connected)
Frost protection:
]
Boiler is running in frost protection mode.
Hour counter menu:
Readout of the operating hours, number of successful
\
starts and hours on mains supply.
Signal strength symbol:
[ Signal strength of the wireless controller (if connected).
3. Technical description
8