Setting The Manual Mode - REMEHA HMI Gas 610 ECO PRO Installation, User And Service Manual

5. Commissioning
2x
2x
21
5.3.7.
In some cases it may be necessary to switch the boiler to manual
operation, For example, if the controller has not yet been
connected. The boiler can be switched to automatic or manual
operation under the symbol E. To do this, proceed as follows:
1. Press the two keys f simultaneously and then key [+] until the
symbol E flashes on the menu bar.
2. Press the S key:
or
The value of the minimum flow temperature.
or
The value of the minimum flow temperature and The current water
pressure (Only with the hydraulic pressure sensor connected).
3. Press the [+] key to increase the flow temperture manually.
bar
4. Confirm the value with the S key. The boiler is now set to manual
operation.
5. Press the > key 2 times to return to the current operating
mode.
T005266-B

Setting the manual mode

HMI Gas 310/610 ECO PRO
051112 - 125482-03