Reading Out Measured Values; Reading The Various Current Values - REMEHA HMI Gas 610 ECO PRO Installation, User And Service Manual

5. Commissioning
5.2

Reading out measured values

4x
2x
11
5.2.1.
The following current values can be read off the information menu
Q:
4 5t = State.
4 5v = Sub-status.
4 t1 = Supply temperature (°C).
4 t" = Return temperature (°C).
4 t4 = Outside temperature (°C)
Only with an outside temperature sensor (Accessory).
4 t6 = Exchanger temperature (°C).
4 5p = Internal set point (°C).
4 fl = Ionization current (µA).
4 Mf = Fan speed (rpm).
4 pr = Water pressure (bar).
Only with the hydraulic pressure sensor connected (Accessory).
4 p; = Supplied relative heat output (%).
4 51 = Pressure switch minimum Gps ( Kz = Not connected /
K1 = Gas pressure OK / K" = Gas pressure incorrect)
Only with connected minimum gas pressure switch (Accessory)
4 5" = Gas valve leak proving system Vps (Kz = Not
connected / K1 = No gas leak / K" = Gas leak present)
Only with connected gas leakage control (Accessory).
4 V1 = Analogue input (V).
4 V" = Analogue output (V).
The current values can be read as follows:
1. Press the two f keys simultaneously. The symbol Q flashes.
2. Confirm using key S . 5t is displayed, alternating with the
current status 3 (for example).
3. Press the [+] key. 5v is displayed, alternating with the current
sub-status 30 (for example).
4. Press the [+] key. t1 is displayed, alternating with the current
flow temperature 60 °C (for example).
5. Press the [+] key successively to scroll down the various
parameters
6. Press the [+] key. The readout cycle starts again with 5t .
7. Press the > key 2 times to return to the current operating
mode.
T004355-A
For operation of the boiler Gas 610 ECO PRO:
The features and instructions described are for each boiler
module.

Reading the various current values

HMI Gas 310/610 ECO PRO
051112 - 125482-03