Exhaust Assy. Removal - VESPA GTS 250 I.E. Workshop Manual

Engine from vehicle
This section describes the operations to be carried out when removing the engine from the vehicle.

Exhaust assy. Removal

- Remove the right and left fairings and the spoiler terminals.
- Remove the Lambda probe from its support and
disconnect it.
Remove the clamp holding the lambda probe ca-
ble to the coolant pipe indicated in the photograph
- Undo the two exhaust manifold fixings on the
head. To undo the nuts fixing the muffler flange to
the head properly, you must use a jointed wrench
that enables you to get at the right nut as well, ac-
cording to the direction of travel, that is difficult to
get at with a traditional straight wrench.
- Undo the three screws fixing the muffler to the
support arm.
Remove the full muffler unit.
ENG VE - 2
Vespa GTS 250 I.E.