VESPA GTS 250 I.E. Workshop Manual page 226

Suspensions
- Use the specific tool to fit the fifth wheel fitting on
the headstock as indicated in the figure
Specific tooling
001330Y Tool for fitting steering seats
- Remove the steering tube
- Remove the attachment bracket
- Use the specific tool with the part 1 and operate
the handgrip until removing temporarily the pin and
the Nadella opposite the tool thrusting direction.
- To extract the second Nadella, use the tool with
the part 2, instead of part 1, on opposite side to the
one indicated in the figure.
Specific tooling
020021Y Front suspension service tool
- Fit the two dust guard rings "C" on the swinging
hub as shown in drawing "A".
- Connect the swinging hub to the steering tube
with the guiding pin, part 5.
- Use the specific tool fitted with part 3 on the stem
and part 4 on the tool base.
- Lubricate the pin with Z2 grease and insert it
temporarily on the swinging hub, move the tool
handgrip until part 3 is fully inserted on the steering
tube.
- Once the pin has been fitted, insert the two
spacers part 17 slightly hitting with a mallet (see
next figure).
CAUTION
USE NEW ROLLER CASINGS, PIN, SEALING
RINGS AND DUST GUARDS FOR REFITTING.
Specific tooling
020021Y Front suspension service tool
SUSP - 8
Vespa GTS 250 I.E.