Rear Brake Pads; Pad Fastening Pin 19.6 ÷ - VESPA GTS 250 I.E. Workshop Manual

Vespa GTS 250 I.E.
- Screw the two pad lock pins to the correct torque, and apply the recommended product.
- Fit the calliper on its support, tightening the two screws to the prescribed torque.
N.B.
IF IT IS NOT POSSIBLE TO CORRECTLY POSITION THE CALLIPER ON THE DISC DURING FIT-
TING, GENTLY EXPAND THE PADS.
Recommended products
Loctite 243 Medium strength threadlock
Medium Loctite 243 threadlock
Locking torques (N*m)
Screw tightening calliper to the support 24 ÷ 27 Pad fastening pin 19.6 ÷ 24.5

Rear brake pads

Removal
- Remove the rear brake calliper.
- Remove the brake pad and check there are no
faults or warping. If there is, replace it.
- Check the thickness of the friction material is
more than 1.5 mm. If it is not , replace it
- The replacement must be made with greater re-
sidual thickness if the pad has not worn evenly. A
0.5 mm thickness difference in the residual friction
material is permitted
Braking system
BRAK SYS - 11