Refitting The Wheel Axle Bearing - VESPA GTS 250 I.E. Workshop Manual

Engine

Refitting the wheel axle bearing

- Support the hub cover on a wooden surface.
- Heat the cover crankcase with the special heat
gun.
- Fit the wheel shaft bearing with a modular punch
as shown in the figure.
- Fit the Seeger ring.
- Fit the oil guard with seal lip towards the inside
of the hub and place it flush with the internal sur-
face by means of the appropriate tool used from
the 52 mm side.
The 52 mm side of the adapter must be turned to-
wards the bearing.
Specific tooling
020376Y Adaptor handle
020360Y 52 x 55 mm adaptor
020483Y 30 mm guide
ENG - 20
Vespa GTS 250 I.E.