Table of Contents
Advertisement
Vantage Stair Lift
REMOTE CONTROL PROGRAMMING
If there are multiple lifts in the home, the infra-red
remote controls can be programmed to work with
individual lifts.
1. Remove the battery door on each IR remote.
2. Move the dip switches to a different code. The two
remotes must be set to the same code.
3. Replace the battery doors.
4. Use the seat control switch to move the lift so that
it is not on a limit switch.
5. Turn the ON/OFF switch to OFF.
6. Swivel the seat toward the upper landing.
7. Press and hold the footrest safety pan to
simulate an obstruction.
8. Turn the ON/OFF switch to ON. Fast beeping
should occur indicating the circuit board is in the IR
Learning mode.
9. Release the footrest safety pan and swivel the seat
back to the normal, riding position.
10. Aim the first IR remote at the chassis, press and
release the UP or DOWN button. The fast beeping
should end with a single beep, indicating that the
first remote is programmed.
11. Aim the second IR remote at the chassis, press and
release the UP or Down button. Two beeps should
sound indicating the second remote is programmed.
32
REMOTE CONTROLS
| www.harmar.com
800-833-0478
© 2015Harmar Mobility, LLC • All Rights Reserved
Hide quick links:
Advertisement
Table of Contents
