CHARGE THE BATTERIES
1. The power supply has a cord with a 2-pin
connector that mates to a cable from the charge
strips. Connect the power supply at either the top or
bottom end of the rail.
2. Plug the power supply into a dedicated
120VAC 15A outlet.
NOTE: The power supply should be connected to
an outlet at all times and the switch on the back
of the chassis must remain on for the batteries to
charge.
TEC0017 23Jan2015 P/N: 630-00027-01 revC
CHARGING SYSTEM INSTALLATION
Vantage Stair Lift
SL400 • Vantage Stair Lift Installation Manual 27
Figure 27-1