Harmar Mobility Vantage SL400 Installation And Service Manual page 21

INSTALLING THE CHASSIS
The chassis is quite heavy and can
be difficult to install on the rail by
one person.
HEAVY
1. Remove the end cap from the top end of the rail.
2. Remove the charge strips.
3. The chassis slides onto the top of the rail. Carefully
pick up the chassis and align the pinion and guide
wheels with the rail channels. Insert the chassis onto
the rail. [Figure 21-1 and 21-2] Let it slide down until
it stops (the pinion gear will make contact with the
gear rack, allowing it to stop). [Figure 21-3]
Ensure that the charge strip wires
at the top are not pinched when
installing the chassis.
CAUTION
NOTE - The chassis may not slide into the rail far
enough to allow for the wheels to be fully inside
the rail. If this is the case, follow the instructions
in this section to lower the chassis further.
1. Using a flat head screwdriver, pry out the white
plastic plug located on the left side of the chassis
where it is marked for Manual Operatiion. This
will allow for access to the end of the motor shaft.
2. Using a 7mm socket attached to your drill and
extension, turn the end of the motor shaft untill
the wheels are within the rail.
TEC0017 23Jan2015 P/N: 630-00027-01 revC
INSTALLING THE CHASSIS
CHASSIS GUIDE WHEEL CHANNELS
Vantage Stair Lift
PINION CHANNEL
Figure 21-1
SL400 • Vantage Stair Lift Installation Manual 21
Figure 21-2
Figure 21-3