Remote Control Operation; Remote Control Reprogramming - Harmar Mobility Pinnacle Series Installation Manual

Remote Call/Send Control Operation
A. REMOTE CONTROL OPERATION
1. Press and hold the
appropriate directional
button on the front of the
hand control.
The chair lift will operate
with or without a rider. All
safety sensors on the chair
lift are designed to continue
to operate in their normal
mode.
2. If the chair lift fails to respond, this may indicate
the batteries are discharged and need to be
replaced. Remove the back cover of the control and
replace with commonly available AAA batteries,
ensuring that the polarity is correct.
72618 P/N: 630-00100 Rev E

REMOTE CONTROL OPERATION

B. REMOTE CONTROL RE-PROGRAMMING
All call/send controls are factory programmed.
Re-programming is not normally necessary during
installation.
In the event that the remote call/send control needs
to be re-programmed, it is essential to program
BOTH controls in one programming cycle. Do so by
completing the following:
1. Start with the red "ON/OFF" switch in the "OFF"
position (0).
2. Disconnect the 6-pin jumper and 8-pin chair wire
harnesses from the chassis.
3. Press and hold the install switch (located on the
top of the chassis) in either direction.
4. Turn the red "ON/OFF" switch to the "ON" position
(I). Wait for circuit board to beep and then release
the install switch.
5. The lift will begin to beep rapidly (this means the
first remote control is ready to program).
6. Press and release the "UP" or "DOWN" button of
the first remote control (the first remote control is
now programmed).
7. Press and release the "UP" or "DOWN" button
of the second remote control (the second remote
control is now programmed).
8. Upon completion, two beeps will indicate that
both remote controls have been programmed.
9. Turn the "ON/OFF" switch to the "OFF" position (0).
10. Connect the 6-pin jumper and 8-pin chair wire
harnesses to the chassis and then turn the red "ON/
OFF" switch to the "ON" position (I).
11. Test each remote control in both the up and
down directions.
Pinnacle SL300
SL300 • Pinnacle Stair Lift Installation Manual
13