Table of Contents
Advertisement
Vantage Stair Lift
6. Remove the end cap fro the lower end of the rail.
7. Assemble the limit cams by placing the supplied
screws into the open side of the cam and loosely
screwing the square nuts onto the screws.
[Figure 16-1]
NOTE: Both cams may be prepared at this time.
Save one for later.
8. Slide the lower limit cam square nuts into the limit
cam fastener channel and onto rail. [Figure 16-2]
The position of the limit cam can be
adjusted later if needed.
TIP
9. Position the end of the cam at 1-3/4" within the end
of the rail. Secure the limit cams with (2) 10-24 screws
and square nuts (provided). [Figure 16-3]
16
PREPARING THE RAIL
| www.harmar.com
800-833-0478
Figure 16-1
Figure 16-2
Figure 16-3
© 2015Harmar Mobility, LLC • All Rights Reserved
Hide quick links:
Advertisement
Table of Contents
