Transport; Removing And Attaching The Media Guide Bar; Removing The Media Guide Bar - Epson SC-F7100 series User Manual

SC-F7100 Series/SC-F7000 Series
E
Unlock the stand.
Release the caster locks on the left and right legs
and fully raise the stand fixing screws.
F
Move the printer.
c
Important:
Use the casters on the dedicated printer
stand to move the printer indoors a short
distance over a level floor. They can not be
used for transport.
Post-Move Setup
After moving the printer, follow the steps below to ready
it for use.
A
Check that the new location is appropriate.
U Setup Guide
B
If the the media guide bar was removed, reattach
it.
"Attaching the Media Guide Bar" on
U
page 116
C
Perform parallel adjustment for the Media
Feeding Unit and Auto Take-up Reel Unit.
"Parallel adjustment" on page 118
U
D
Plug in the power cables and turn the printer on.
U Setup Guide
User's Guide
Appendix
E
F

Transport

Before transporting the printer, contact your dealer or
Epson Support.
Removing and Attaching
the Media Guide Bar

Removing the Media Guide Bar

Parts used in the following operation
A
B
113
Perform a nozzle check to check for clogged
nozzles.
"Checking for clogged nozzles" on page 69
U
Perform Head Alignment and check print
quality.
"Head Alignment" on page 58
U
Confirm that the printer is off.
Remove the media guide bar.
Use the included hexagon wrench (small) to
completely loosen the 4 screws securing the
media guide bar, and then remove the media
guide bar.
c
Important:
Remove the bar using two or more people. If
the media guide bar locking screws are
removed, the media guide bar will fall. Have
one person hold the media guide bar while
the screws are being removed.
If the media guide bar falls, it may be
deformed.