Epson SC-F7100 series User Manual page 139

SC-F7100 Series/SC-F7000 Series
O
Keep the adjustment paper taut and check the
positions of the white line on the platen and the
line drawn in Step 13.
If the drawn line and white line are misaligned as
shown in the illustration to the right, proceed to
Step 16. If they are aligned, proceed to Step 19.
P
Use a hexagon wrench (small) to loosen the 2
screws.
User's Guide
Appendix
Q
R
139
While checking the state of the two lines, use the
hexagon wrench (large) to adjust the screw so
that the drawn line aligns with the position of the
dotted line.
While pressing on the media guide bar with your
hand, align the lines by rotating the adjustment
screw. If the drawn line is below the white line,
rotate the adjustment screw counterclockwise. If
the drawn line is above the white line, rotate the
adjustment screw clockwise. One turn of the
screw moves the line about 1 mm.
Use a hexagon wrench (small) to tighten the 2
screws.