Epson SC-F7100 series User Manual page 41

SC-F7100 Series/SC-F7000 Series
Buttons that are used in the following settings
A
Confirm that the printer is ready to print.
B
Press the button and the Z button. The
printer will feed the trailing edge of the printed
media to a position over the cutter groove.
If you have printed the amount of media
remaining, press the u button to rewind the
media so that this information will remain on the
roll after the media is cut.
User's Guide
Basic Operations
C
D
Note:
If you are using the Auto Take-up Reel Unit, set the Auto
switch on the Auto Take-up Reel Unit to Off before using
the Manual switch to position the media over the cutting
groove.
41
Remove the media holding plates.
Cut the media with the cutter.
Pass the blade of the cutter down the cutting
groove.
c
Important:
To continue printing after cutting, do not rewind
the media past the cutter groove (on the pressure
roller side).
If the leading edge of the media is curled, stop
rewinding before the media reaches the inner side
of the front cover.