Epson SC-F7100 series User Manual page 83

SC-F7100 Series/SC-F7000 Series
E
Attach the chip unit supplied with the new ink
pack to the slider.
Check to confirm that the color of the label on the
slider matches the color of the label on the chip
unit when installing.
F
Hold the slider level and insert it, then lower the
lock lever.
c
Important:
Do not push the slider in with too much
force. Failure to observe this precaution
could damage the printer.
User's Guide
Maintenance
G
H
I
83
Shake the new ink pack as shown in the
illustration horizontally for approximately 5 cm
left and right for 5 seconds approximately 15
times.
Open the slider ink inlet cover.
Remove the ink inlet cap from the ink tank.