SC-F7100 Series/SC-F7000 Series
S
Pull out the adjustment paper from the printer,
loosen the left roll core holder locking screw, and
remove the roll core holder.
T
Remove the roll core.
When using the SC-F7000 Series
A
Raise the tensioner up and set it near legs for this
procedure.
B
Use a hexagon wrench to loosen the 4 screws.
User's Guide
Appendix
C
D
140
Loosen the roll core holder locking screws and
adjust the roll core holders so that the distance
between the two is wider than the roll core.
Tighten the roll core holder locking screw to
align the right roll core holder with the position
of dotted line.