Table of Contents
Advertisement
SC-F7100 Series/SC-F7000 Series
Take-up with the Printed Side Facing
Out
A
Attach the media to the take up roll core with
tape.
In the order shown in the illustration, tape the
media to the take up roll core. When attaching in
the center, attach using tape while pulling the
center of the media straight. When attaching on
the left and right, attach using tape while pulling
the media sideways.
c
Important:
If the media is lifted up between the attached
pieces of tape, the media will not be taken up
correctly. If the media is lifted up, we
recommend either adding tape and
attaching it uniformly or fixing creases at
the leading edge of the media.
B
Press the d button in the control panel to feed
enough media for a single wrap around the roll
core.
User's Guide
Basic Operations
C
52
Flip the Auto switch to Off, and then press and
hold the Manual switch to
media once around the roll core.
c
Important:
Confirm that edges of media taken up on the
roll core are not misaligned. If the edges are
misaligned, the media that follows cannot
be taken up correctly. When the edges are
misaligned, press the Manual switch to the
side, rewind the media, remove the
tape, and then repeat from Step 1.
to wrap the
Advertisement
Table of Contents
