Table of Contents
Advertisement
SC-F7100 Series/SC-F7000 Series
Problem Solver
When a Message is Displayed
If one of the following messages is displayed, read and follow the instructions below.
Messages
Prepare empty waste.
Chip Unit Error
Chip unit not recognized. Reattach
or replace.
Chip Unit Error
Chip unit not recognized. Refill
after matching ink pack with label?
Check Ink Levels
Command Error
Check print settings on RIP.
F/W Install Error
Firmware update failed.
Restart the printer.
Take-up Error
Flip Auto switch to off and reattach
media to roll core.
Refer to manual for details.
User's Guide
Problem Solver
What to do
The Waste Ink Bottle is getting full. Ready a new Waste Ink Bottle.
"Options and Consumable Products" on page 111
U
❏
Remove and reinsert the chip unit. If the same error still occurs, replace with a new
chip unit.
"Chip Unit Replacement and Ink Refills" on page 81
U
❏
Condensation may have formed inside the tank. Keep at room temperature for at
least 4 hours.
"Notes on Handling Ink Packs and Ink Tanks" on page 23
U
Use only the chip units from specified Epson ink packs.
You cannot use unspecified Epson ink packs.
"Options and Consumable Products" on page 111
U
Chip unit is nearing end of service life. Obtain an ink pack of the appropriate color as soon
as possible.
Check the remaining ink in the ink tank via the scale on the ink pack. When remaining ink is
70 mm or less from the bottom of the ink tank, replace the chip unit and refill the ink. If the
remaining ink level is greater than 70 mm from the base of the ink tank, continue use until
the remaining ink reaches 70 mm.
"Options and Consumable Products" on page 111
U
"Notes on Handling Ink Packs and Ink Tanks" on page 23
U
"Chip Unit Replacement and Ink Refills" on page 81
U
Press W and select Job Cancel. Check that the installed software RIP is compatible with
the printer.
Turn the printer off, wait for a few minutes, and then turn on the printer again.
Use EPSON LFP Remote Panel 2 to update the firmware again.
If this message appears on the LCD panel again, contact your dealer or Epson Support.
(This message is displayed for the SC-F7100 Series only.)
Media is not correctly attached to the Auto Take-up Reel Unit.
Flip the Auto switch on the Auto Take-up Reel Unit to Off, flip it back, and then reattach the
media to the Auto Take-up Reel Unit.
"Media Loading (SC-F7100 Series)" on page 42
U
102
Advertisement
Table of Contents
