Table of Contents
Advertisement
SC-F7100 Series/SC-F7000 Series
T
At the rear of the printer, remove the
counterweight attached to film a.
U
Pull out film a from the printer. Next, loosen the
right roll core holder locking screw and remove
the roll core holder from the roll.
V
Remove the roll core.
User's Guide
Appendix
W
X
Note:
Store film a and b with the counterweight without
creasing them. If film will be used again, remove dust and
other objects and stretch it well before using it.
Parallel adjustment using Tool B
The following procedure uses illustrations of the
SC-F7000 Series, but the procedure is the same for the
SC-F7100 Series.
Parts used in the following adjustment
Two hexagon wrenches are included with the SC-F7100
Series. For parallel adjustment of the Media Feeding
Unit, use the large hexagon wrench.
129
Remove film a from the roll core.
Remove the left and right side of film b from the
printer.
Advertisement
Table of Contents
