Conference Settings - Cisco TelePresence MX700 Administrator's Manual

Cisco TelePresence MX700 and MX800
Contents

Conference settings

Conference [1..1] ActiveControl Mode
Active control is a feature that allows conference participants to administer a conference
on Cisco TelePresence Server using the video system's interfaces. Each user can see the
participant list, change video layout, disconnect participants, etc. from the interface. The active
control feature is enabled by default, provided that it is supported by the infrastructure (Cisco
Unified Communications Manager (CUCM) version 9.1.2 or newer, Cisco TelePresence Video
Communication Server (VCS) version X8.1 or newer). Change this setting if you want to disable
the active control features.
Requires user role: ADMIN
Value space: <Auto/Off>
Auto: Active control is enabled when supported by the infrastructure.
Off: Active control is disabled.
Conference ActiveControl Mode: Auto
Example:
Conference [1..1] CallProtocolIPStack
Select if the system should enable IPv4, IPv6, or dual IP stack on the call protocol (SIP, H323).
Requires user role: ADMIN
Value space: <Dual/IPv4/IPv6>
Dual: Enables both IPv4 and IPv6 for the call protocol.
IPv4: When set to IPv4, the call protocol will use IPv4.
IPv6: When set to IPv6, the call protocol will use IPv6.
Conference 1 CallProtocolIPStack: Dual
Example:
D15119.02 MX700 and MX800 Administrator Guide TC7.2, AUGUST 2014.
Introduction Web interface System settings System settings
Conference [1..1] AutoAnswer Mode
Set the auto answer mode. Use the Conference AutoAnswer Delay setting if you want the
system to wait a number of seconds before answering the call, and use the Conference
AutoAnswer Mute setting if you want your microphone to be muted when the call is answered.
Requires user role: ADMIN
Value space: <Off/On>
Off: You must answer incomming calls manually by tapping Answer on the Touch controller.
On: The system automatically answers incoming calls, except if you are already in a call. You
must always answer or decline incoming calls manually when you are already engaged in a
call.
Conference 1 AutoAnswer Mode: Off
Example:
Conference [1..1] AutoAnswer Mute
Determine if the microphone shall be muted when an incoming call is automatically answered.
Requires that AutoAnswer Mode is switched on.
Requires user role: ADMIN
Value space: <Off/On>
Off: The incoming call will not be muted.
On: The incoming call will be muted when automatically answered.
Conference 1 AutoAnswer Mute: Off
Example:
Conference [1..1] AutoAnswer Delay
Define how long (in seconds) an incoming call has to wait before it is answered automatically by
the system. Requires that AutoAnswer Mode is switched on.
Requires user role: ADMIN
Value space: <0..50>
Range: Select a value from 0 to 50 seconds.
Conference 1 AutoAnswer Delay: 0
Example:
www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved.
69
Administrator Guide
Setting passwords Appendices